left margin is too large so all the content is shifted to the right and off the page? If this is the case, it is probably a setting in Pagemaker. In the file menu, choose "page setup" or "print setup"
Question about MICROLINE 520 Matrix Printer
...left and alarm light goes on. Clean the large silver rod that runs through the carriage. It is dirty and not allowing the carriage to move as freely as it should. Ideally it should be left dry. Also ...
...left margin on the page are streaked pink/red. I printed a test page, and the colors appear to be full. My supply levels show that they are full, but only black prints completely. How do I fix the ...
...left margin other times it spreads across most of the page. On a large print run each individual page has varying degrees of this effect. I recently change the toner cartridges for Inkrite branded ...
...left margin and runs off the page on ther right. check your print settings before you print anything. the left margin might be from the ink cartridge not going all the way over or it could be blocked ...
left margin which means 1 to 2 inches on the right is cut off and student's assignments are cut off. I have tried things and nothing seems to work. Any suggestions? Hi fsaltzman, You need to check
Question about DR6050C A3 Document Scanner 60PPM
left margin) and change the settings (select reverse scanning, i.e, bottom side only) and alter the margin as required, nevertheless you will have to scan twice. You can also crop after the images are
...left margin. The large orange feed roller at the back has the streak on it, but I can't see where it is coming from. Any suggestions. Clean the roller and the inside of the machine, asny ...
Question about MFC-8870dw Wireless Multifunction Laser Printer
...left hand margin of each printed page approx 10cm apart. MFC8870DW Copies, faxes, anything that is printed 10cm means it's caused by a large roller. The only roller large enough for that would be in ...
Question about MFC-8870dw Wireless Multifunction Laser Printer
...left margin One thing to try is the large medal rod that the printwheel carrier rides on from one side to the other gets durty. clean off and then apply a small amount of oil such as 3n1. turn off ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions