...left to right) you will get this error code. Find the sensor and clean it with a small wire brush. Make sure what you think is the flame sensor is the flame sensor because the ignitor is very brittle ...
Question about GMS90703BXA Heater
...left back burner won't light. hear clicking i have a gas kitchenaid stove. The back left burner won't ignite. It clicks but has no flame. what do i do? It's the 30 inch pro range model. MOdel KDRP407 ...
...but I removed all the burner caps and cleaned each one with a tooth brush. Then using a metal trussing pin, I poked through the flame holes to clean them. Noticed better flame output from
...front left burner. Now the right back burner is burning low (the flame is about half the height as it used to be when turned to high). Is there something wrong with the stove, or could be a problem ...
...burner on these. I was reading the installation manual and see there is an adjustment screw for the flame height. Would it be reasonable to adjust this so that the flames are higher and therefore ...
...front left burner is 1/3 orange and 2/3 blue; whereas the flames from the other burners are all blue. There is a strong odour from the front left burner when we turn it on and also the sides of the ...
Question about Profile JGS968 Gas Kitchen Range
...Left front) Flame very low on "high" back right burner is much higher on high. Is there an adjustmant to take care of this problem? There is an air port near the adjustment knob. Open ...
Question about 79012 / 79014 / 79019 Gas Kitchen Range
...left front burners high flame onright front burnners my front left burner is very low in the hi knob pos. my right front burrner is very high in the hi knob pos can I adj ?? That is food/grease ...
kitchenaid stove burner Front right burner turns on but the flame does not adjust. Stays at same level from hi to lo You need a new gas valve for that burner
...burner flame adjusted flames coming from underneath of front burners Most burners have an adjustment under the knob. Pull off the knob and use a slender flathead screwdriver. Turn burner down to low, ...
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions