...LEARN button TWICE. The red indicator blinks off. 4. Press and release the SETUP button. The red indicator turns off. All learned Commands under that mode are now cleared. Master Clear - To Clear all ...
Question about Harmon Kardon SoundStick II Speaker System Computer Speakers
...Learn Button until the Source Selector lights up, then release. Learning Remote Commands c) Press the button on the AVR 350 remote you wish to program with the new code, and the Source Selector will ...
...LEARN] button on the JUMBO Remote. (light will immediately blink rapidly.) 3. Now Press the {NEEDED} button to program. (light will stay solid) 4. Now (1 to 2 inches away) have the ORIGINAL Remote ...
Question about 3301 Thermostatic Gas Fireplace & Gas Stove Remote Control System
learn button It's there, but you may have to remove the large slide switch to see it. The slide switch just pulls off. The learn button is on the right side if the face of the remote box, under the ON
learn the command. After a button has learned a command successfully, repeat steps 3 and 4 until all commands you want have been learned. To end the learning sequence: Press one of the mode buttons on
Question about 1001-A Fireplace Remote Control On/Off
LEARN button on the receiver to accept the transmitter security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer or the factory. In order
Question about 1001-A Fireplace Remote Control On/Off
...learn" button. Press and hold the "learn" button for 12 seconds. When you release the learn button, the red light above the button will blink 3 times and then come on bright for 15 seconds. When the ...
Question about 1001-A Fireplace Remote Control On/Off
...learn" button on the garage door opener? We are trying to install a new remote opener to this 1145lm opener. our remote has died - we bought a new chamberlain remote at home depot and it says to find ...
Question about 1001-A Fireplace Remote Control On/Off
learn button on merlin 430r garage door opener It's an older model than the one with the green cover. Hi, The location of this button should be described in the products manual. If you don't currently
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions