...etc. i don't know what happened what should i do?? Check LCD ribbon cable. 99% LCD ribbon cable is defective. Replace LCD ribbon cable. What's an LCD ribbon cable, and where is
cable that connects the LCD screen to the circuit board is loose somewhere. In order to fix this, you will have to carefully disassemble the camera. Inspect the ribbon cable to see if it is loose. You
Question about Inspiron 1150 Latitude D600 14.1 LCD Display-LP141X14 CD-ROM Drive
LCD flex cable. You must have an SXGA flex cable for an SXGA screen; with the old XGA cable you get lines. Unfortunately the only SXGA cable I could find for the 1150 is about an inch shorter than the
Question about Inspiron 1150 Latitude D600 14.1 LCD Display-LP141X14 CD-ROM Drive
...LCD CABLE OVER AND DOWNLOADED THE LATEST DRIVERS FROM THE INTERNET, COULD IT BE THE INVERTER? OR THE SCREEN? OR IS THERE SOME SOFTWARE TO ORRECT THIS..REGARDS - COLIN the inverter only control the ...
...closed This is due to some loose contact of your LCD Cable connection or LCD Panel cable malfunction. Reinsert LCD panel cable in proper way and check else you need to replace the LCD Panel
...LCD cable.Carefully lift the adhesive tape securing the cable connector to the LCD Panel. 5. Hold the adhesive tape clear of the LCD Panel and disconnect the LCD cable as shown. Remove the adhesive ...
...Cable to the LCD, you have to buy a TV Box and connect Cable with your LCD through TV Box. (Cable TV to TV BOX and from TV BOX to LCD) Hope it helps! Good Luck! Thanks for using Fixya! ...
Question about SyncMaster 2233BW 22" LCD Monitor
Cable/LCD cable or the LCD itself is defective, because if you still see the contents of the laptop to an external monitor, then it means that the rest of the computer's components are working.You
Question about SyncMaster 2233BW 22" LCD Monitor
...LCD cable is unplugged, yet I can still see stuff on the screen. I still have backlight too. I checked to make sure the plugs see seated well but still have the lines. I got a new LCD cable and ...
Question about SyncMaster 2233BW 22" LCD Monitor
Cable (LCD Cable) is not connected tightly. Motherboard side, or LCD screen side; or both. 3) IF, a screen Inverter is used, the small cable from the Video Cable, that connects to the screen Inverter;
Usually answered in minutes!
371 Questions
397 Questions
331 Questions
310 Questions
259 Questions