Questions & Answers for: lawn boy self propelled speed

self-propelled Lawnboy rerunning the belt on an 06 self-propelled Lawnboy. The belt came off of the back wheel and I can't seem to get it back on. Any tips? You may have to loosen the adjustment a bit

my engine surges,i tryed to adjust the gonvoner and now it just races and wont idle down adjust the govenor back to where is was. You have a partially plugged carb

I can push the handle all the way in, but I get very little speed from the mower. Your throttle cable likely needs adjusting. It should be fastened on the engine with a screw. Loosen that screw and ...

engine is running rich, fowling spark plug. how to adjust to run leaner? put new plug in, cleaned air filter. using alot of gas. clean your carb and change needle and seat also

Lawn Bow Mover self propel option not working have already adjusted the drive cable check the belt

mower runs no power adjust govenor at carberator

Husqvarna Problems butterfly on carb will not close after cooling adjust throttle controlso it will close

Lawnboy 10665 won't self-propel and impossible to push Lawnboy 10665 won't self-propel and is impossible to push - when engaging self-propel drive you get a squealing noise and the smell of ...

model 10640 how to adjust self-propel drive cable If the V-belt is old, you'll need to install a new V-belt first ,then IIRC,the adjustment is by sliding the bale conduit on the side of the handle.

...Lawn-Boy mower. It hunts up and down. Model # 10323, Serial # 200005626 Speed is unstable Speed control for motor is controlled by an automatic governor, so there isn't any adjustments. Surging is ...