Questions & Answers for: laars pool heater ags code

...AGS, heater wont light My heater wont light the blower comes on but the pilot never ignites and I dont smell any gas . the AGS code comes on, is there a reset switch ? and where would I find it if ...

Laars lx 250 fault code "AGS" I've had the unit for about 5 years and have had problems in previous years. In this case the igniter seems to be working fine, the blower works however, there is ...

...heater is giving me service code ags AGS automatic gas shut down which means you have ignition failure, which can be from low gas pressure, or volume. if the heater fires then goes out the signal is ...

ags code? not flame rectification this is due to plug burners bad gas valve or valve close

...ignite. Pilot light glows but then kicks off. I get an error code of AGS. You either have the gas shut off or the gas valve in the off position. If this doesn't do it then you have a bad control ...

...heater and i get a code that says service ags what does this mean Automatic gas Shut Off . The system Locks out if it does not ignite. Shut the power off to the unit at the breaker then try to start ...

...laars XL400 propane pool heater. I used the heater and it was blowing out black soot. Unit is about 4 yrs old. I noticed that my propane was very low in tank, less than 10%. Had tank filled, but now ...

Laars pool heater wont start. I have a Laars Lt400N-L pool heater that wont start. When power is applied, there is a single short flash on the ignition controller. The diagnostic code indicates an ...

...minutes approx, then shuts down> AGS display code. Most likely reasons and troubleshoting solutions? Thank you. ags is automatic gas shut off. laars are notorious for the flamesensors crapping ...

...heater started a week ago when I opened the pool. The temperature went up to 77 then the heater shut off. I have not been able to get it to run since. It starts and within 5 seconds it shuts down and ...