silverado 2500 with a 6.0 motor the service engin soon light comes on for awhile and then it goes out ,and then back on.the engin keeps cutting out,almost like a missfire i was told by a machanic that
...KNOCK SENSORS WHAT CAUSES THEM TO GO OUT I HAVE REPLACED KNOCK SENSORS INTAKE GASKET AND THE WIRING HARNESS TO THE KNOCK SENSORS Make sure you are not over torquing it. if you screw it in to much, it ...
where is the knock sensor and how do you replace it keeps triggering my check engine light to come on Thanks! The knock sensor is most likely ok you need to do a top engine clean to get the combustion
...Knock sensor, O2 sensor have all been replaced. I'm not getting any codes. When I start it I have to play with the throttle to keep it running. Sometimes its running rich enough that it smokes and ...
...knock sensors the other day truck ran fine for a while then two more codes came up po107 and po449 where should i go know The two codes may refer to the same fault/ THe p0107 says that the Manifold ...
...keep knock away. Verify that your timing is correct, and that the EGR system is functioning correctly. EGR plugs up and it cools the burn temprature in the combustion chamber. Do not let it go on. ...
...knock censor low input HI . make sure the two sensors are replace from the dealer along with the harness going to the top of your intake and make sure they silicone the plastic grouments that cover ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
