Questions & Answers for: kind wrench need tighten water

...need a large wrench and something to stop the pully from spining while loosening and tightening that nut. should take about 2 hours or so. IIRC13mmm, 15mm bolts, 9/16 bolts and 10mm and 8mm bolts. ...

...a 2005 GMC Envoy and cannot remove the fan clutch in order to replace the water pump. get a big adjustable wrench and insert it in the bolt and hammer it fast in one blow that should solve your ...

I have a 2003 GMC Envoy with a loose shifter lever. How do I access the screw that tightens? There is a set screw on the drivers side. You will need an allen wrench.

...a water pump on my 2005 GMC Envoy 4.2L 4wd Remove belt,center pulley, fan, and three bolts holding pump on. When tightening bolts, find out torque spec first, those little bolts will not take

...wrench, I believe a 32 mm, and a hammer, the threads are rihgt handed 3 remove the water hoses 4 remove the pump 4 bolts 5 clean all the gasket material off the engine 6 reinstall everything in ...

2002 gmc envoy water pump Hi, Will need specific info to help. Are you looking to replace the water pump and need instructions? If so, will need to know engine size in your Envoy. Thanks, Mike

...NEED A PIN SPANNER WRENCH OR STRAP WRENCH TO HOLD WATER PUMP PULLEY WHILE LOOSEN WATER PUMP PULLEY BOLTS .YOU CAN BUY STRAP WRENCH OR RENT PIN SPANNER WRENCH AT AUTO ZONE PARTS STORES OR OTHER STORES ...

...need a 34mm wrench to get the fan clutch removed from the water pump. Once the fan clutch is unthreaded and the bolts that hold the fan shroud to the radiator are removed you will be able to remove ...

if i replace the clutch fan on a 2005 gmc envoy, does the water pump need to be replaced as well? No, unless the front bearing on the pump wobbles a lot.

tighten bolts using socket wrench. Reconnect electrical - Reconnect electrical connections. Test engine - Start engine and check for leaks or issues. Note: This is just a general guide. Steps may vary