Questions & Answers for: kerosene heater wont light

200T would burn sat all summer went to use it wont light During start up, a hot surface ignitor glows brightley to ignite kerosene, check to see if it is broken

heater wont light I have a fairly new 170000 ready heater that wasnt pumping fuel I found that the rotor assembly was broke and replaced it it now pumps fuel and sprays out nozzle but wont ingnite ...

...kerosene so why wont it reset and warm up? Your problem may be a dirty flame sensor which can be cleaned with some steelwool. If the heater makes a ticking or thumping noise before it cuts off it is ...

wont start at all. Hi, Here are a couple of tips that I wrote that tell you how to troubleshoot a Torpedo or Reddy heater... Reddy Heater - Troubleshooting Torpedo Heaters Torpedo Heater Pump Pressure

...heater wont turn on power light comes on but nothing happens. wildrose41, I would remove the cover to get to the circuit board and inspect or resolder all the connetions on the board. Also check any ...

turn on wont ignite if does smokes take top coveroff works fine Must be starving for air then, check and make sure it is clean and unobstructed and air can get in around the finns to the flame. Is the

...fires but wont light what should the pressure gage read? i have fresh kerosene good spark but no flame I'm guessing this is a kerosene forced air heater. the pressure for a 210k pro fitter is 8.5

wont run plug in switch lights up turn on nothing happens May need to reset the safety switch. Should be located near the motor.

...kerosene heater wont start, igniter lights then cuts off. i cleaned fuel filter and air filter. and burner .. i dont know how to check or clean the photo cell.. any help If you can get to the ...

how do i bypass the themstat on a workhorse heater i get fule and wont light As you should know thermostat is for safety and it is not good idea to by pass it ,not recommended