Questions & Answers for: kenwood excelon protect mode

...kenwood KVT-717DVD and it does the same thing if the radio is too hot or cold it will put it self into protect mode, sometimes if u let the unit rest 4 a lil it will b fine other times u have to find ...

it comes on but the power light start flashing and the fan screen I believe that the amplifier is in protection mode; more than likely you either have an internal short in the amp or a bad speaker ...

Kenwood KDC-X492 where is the reset button???? i need to reset it out of protect mode and it says press the reset button but there is none not even on the graphic in the manual that labels all the ...

...Kenwood KAC X812D out of protection mode? Apparently it locked up because of the E-03 code (speaker power wire came in contact with ground) turn the ign off and then back on, or disconnect the power ...

...kenwood car stereo excelon kdc-x591 it says protect and does not play at all Hi. Protect mode start when the internal control circuit detects a fault, like a wrong voltage or a short. When protect is ...

...kenwood excelon x1200m was operating fine when all of a sudden it stopped. When I arrived at my destination, I was able to see that the amp had enters protect mode. So I checked all the wires to see ...

kenwood stereo is going into protect mode, it is because one of ur speaker wires is shorting out. Make sure all of ur speaker wire connections are good, and then wrap them so they aren't grounding out

kenwood excelon kdc 994 protect mode i can't get it off of protection mode Try checking all of your speakers and speaker wires for shorts and/or grounds.  If they all check out, try ...

...Kenwood Excelon Monoblock 1200 Watt Class D Amplifier out of safe mode the light is on and i tryied everything protect mode is often due to faultiy speaker wiring, or too many spoeakers .tool little ...

Excelon kdcx598 is in protect mode Disconnect all speakers and push reset button. Then reconnect speakers one by one when the defective speaker is connected the unit will return to protect mode. ...