Questions & Answers for: kenmore washer clothes wet spin

...kenmore elite washing machine It is not spining the clothes correctly they are still really wet wet and the machine is not over loaded . My washer will spin, but not spin out enough. It seems to spin ...

clothes at end of spin cycle hello, i have a Kenmore 110 22422100 that does not seem to be spinning fast enough on the spin cycle. the clothes are still wet at end. the water is being pumped out, just

Kenmore series 90 washer spins but the clothes are still very wet The washer runs the complete cycles no problem. However, after is spins the clothes are still very wet. The machine does spin but not ...

...spin cycle After the spin cycle, the clothes are still dripping wet? What can I do? adjust your loads. balancing issue If they're soaking wet, it's the wax pump. It pumps the water out of the

Kenmore 41748102701 Front Load Washer - no spin cycle. Agitate: yes, drain: yes, I think. But no spin cycle. Tried various cycles and only one successful spin. Clothes come out sopping wet. replace ...

...high, medium and low speeds. It is a Kenmore front load washer HE plus. What could be wrong...I've only had the machine for 14 months. sounds like not pumping very well, try cleaning the filter/ ...

...clothes in washer are still too wet Washer is 8 years old, and this is a recent issue. Unit cycles properly, but clothes are too wet to transfer to the dryer after spin cycle. Check for obstructions ...

...spin cycle is over on my kenmore elite top loader washer. Please advise Be sure drain hose is not kinked and no higher than the top of washer to drain pipe. Remove clothes as soon as it stops ...

...Kenmore washer Model 110.22722100. The last couple of weeks, it leaves the clothes wet. It drains like it is supposed to and spins. What is causing this to happen? If the washer doesn't reach its ...

...kenmore washer and I have to run everything thru 2 spins cycle If the washer doesn't reach its proper spin speed, the clothes may be too wet at the end of a cycle. Check to be sure the load is ...