Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
Kenmore sewing machine - uneven top stitches I reset the tension because I was getting looping on the back. I took off the throat plate and cleaned out all the lent. Now, the top stitches are not the ...
...is not solved I am afraid you need a sewing machine tech to have a look at it. It would be interesting to know the make of machine and how old it is, plus when it was last serviced. Best of luck ...
...sewing. If the machine works on regular stitching and only messes up on free motion ,the most likely problem is the presser foot has not been lowered. Get everything ready to sew, lower the presser ...
Question about 19233 Computerized Sewing Machine
...been done, that might help to. Hope you get it working! I love this machine, it works well and is good quality. (they don't make sewing machines like they used to, the only one I'll buy is a
...sewing two layers of material with batting between, my machine seems to push the top layer of material ahead of the bottom layer. I've tried adjusting the tension, width and stitch length and I can't ...
Question about 5050 Mechanical Sewing Machine
...sewing in no time. Just remember to put in new needle, pushing all the up into the needle bar before tightening the needle clamp screw, and raise your presser foot BEFORE you thread your new needle ...
...Kenmore Sewing Machine model 385.16765 First time using a sewing machine so I'm lost! Bobbin winding, inserting bobbin,threading the machine, and drawing up bobbin thread are all ok. I chose a ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
...machine. Hello Crystal, I also have had problems in the past with drop-in bobbins . I had to experiment with different model bobbins . The cause I found was due to the bobbin was not tall enough in ...
Question about Drop-In Bobbin 16231 Mechanical Sewing Machine
Kenmore 19233 very new. When using the zig zag stitch, only reliable at 2mm or less. Increasing width to 7mm results in a straight stitch with a few zig zag blips. Changed to a new needle, changed to ...
Question about 19233 Computerized Sewing Machine
Kenmore 19233 refuses to zig zag stitch past 2mm wide. At 2mm it is a reliable stitch, moving toward 7mm it is a straight stitch with one or two zig zag blips. Machine is new, all other stitches work,
Usually answered in minutes!
760 Questions
764 Questions
564 Questions
565 Questions
372 Questions