...Kenmore seies 80 top load machine works fine, goes thru the cycle. The clothes are still soapy at the end of the rinse cycle.I am not using to much detergent. The thing I don't hear is the spray of ...
...warm sounds like your washer has an auto temp. control if so the washer mesures the temp of the water and put in the manufacture set temp for that setting this board could be bad alowing only cold ...
...washer. On that setting the water fills the tub with only "hot" water however the warm/warm water temp works and cold/cold water temp works. Most of my loads I want to use a warm/cold setting but ...
Kenmore 400 washer on warm cycle begins to fill with warm water and then it turns cold. Repairman can't seem to figure what is wrong. This is a brand new washer. When the water turns cold, check the ...
Washer will not fill up with hot water however it will with warm Is your water temp on your water heater set high enough? If it is sounds like you are getting water from both hot & cold water ...
Question about 24032\24036 Top Load Washer
...Kenmore Elite total care system gets stuck on the Pause Cool Down step and then again on the spin setting. It doesn't even drain after rinsing. The washer has a temp sensor for the rinse cycle , so ...
Question about 24032\24036 Top Load Washer
...Kenmore 80 Series Hvy Dty Washer? How do I check and replace the "water level sensor" on my Kenmore 80 Series Hvy Dty Washer? Water will not shut off on while filling the drum on any water level ...
Question about 20022 3.4 cu. ft. Top-Load Washer
...Warm setting, the water is same temp as cool or cold. Can't tell a difference. to achieve warm water, must run on COLD for a time then change to 1 yr old purchased 8-2013 What is the model
Question about 20022 3.4 cu. ft. Top-Load Washer
...kenmore seiries 80 washer was stuck aggitating for several hours. I found the whole machine very hot. Now it seems to move slower aqnd squeeks alltime. What can fix it? Cold/wash and rinse to start ...
Question about 20022 3.4 cu. ft. Top-Load Washer
Kenmore 80 series washer , model #92281100 is leaking when I use warm water If it is only leaking when you use warm water it is likely a leak from the delivery side of the hot water inlet solenoid. ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions