kenmore dryer belt pulley appears to have come off, belt is loose, pulley found unattached on the floor of dryer - how to fix? [email protected] The pully fits in some groves at the bottom of ...
...how to put the belt back on, I was looking for the schematics for the belt, maybe? if whirlpool are kenmore the pulley slides in tobottom of the dryer in front motor there a slot it goes ...
MOISTURE WHEN MY DRYER HAS BEEN RUNNING FOR AWHILE, I NOTICE MOISTURE ON THE FLOOR IN FRONT OF THE DRYER--WHEAT COULD THE PROBLEM BE? Your vent is terribly clogged or poorly built.
Gas Dryer won't Dry I have an old 110 series kenmore gas dryer, i've cleaned out all the vents and replaced the heat surface ignitor, but no glow. I don't hear the gas valve click on. The motor runs. ...
i have a kenmore 90 series dryer, the drum belt broke, bought a new one, but cant figure out how to get it on, too much slack in the belt, not sure where it goes on REMEMBER BELT GOES AROUND IDLER ...
Question about 64952 Electric Dryer
Dryer won't run unless you manually hold down the "on" button. Kenmore model 68942. im not sure which dryer you have but ther is a electonic control on some start buttons if you dont have that the ...
Kenmore dryer (64952) runs but no heat... Looked at heating coil and it looks good (no bends/break/scratches). Help!!! Good day, Looking might be deceptive. You'll need a VOM meter to be sure. The ...
Question about 64952 / 64954 / 64959 Top Freezer Refrigerator
Though Freezer is working fine, this model 64952 (6.5 yrs old; limited vacation home use only) has not properly cooled fridge portion for a few months. At first, it (also) wasn't defrosting, and water
...Kenmore 64952 / 64954 / 64956 Electric Dryer For replacement parts - head on over to PartSelect.com or RepairClinic.com and enter in your full model number for a full parts listing.I recommend both ...
Question about 64952 Electric Dryer
My kenmore elite electric dryer runs and gets hot but it keeps shutting off and then it restarts later if the timer has not ran out. What could it be? It is very possible that the motor is shorting ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions