...heating it with a propane lighter, and it raised from 475 Ohms at room temperature, to 600 ohms, so I knew it was functioning. Then, I plugged in a variable resistor where the thermostat plugs in. I ...
...heating it with a propane lighter, and it raised from 475 Ohms at room temperature, to 600 ohms, so I knew it was functioning. Then, I plugged in a variable resistor where the thermostat plugs in. I ...
Question about TOB-30 Toaster Oven with Convection Cooking
...touching the metal on the plate like they are supposed to? If not, try bending them so they will touch when closed by the cam (but remain open when the cam is not pushing them). Are the contacts free ...
...element WE11X260 coil kit. I recommend replacing both coils even if only one is open. Procedures for Replacing the Heater Coils If you have skipped the data gathering steps above, unplug the dryer, ...
keep the element aligned, and prevent bending of the face plate. Tighten them so the element will not wiggle or move, but NOT too tight, forcing it. since you may need to replace this element someday,
Question about 24" Built-In Single Gas Wall Oven
...heating chamber or does not stay consistant. Performing a continuity test on either part will help you determine whether or not you need to replace it. But the coils should also be tested for amount ...
Usually answered in minutes!
924 Questions
608 Questions
343 Questions
293 Questions