Question about 20.4GB 7200rpm ATA-100 HDD p/n 5T020H2 ATA-100 Hard Drive
...maxtor as 2nd drive...need to change from master to slave on pin settings... hi frined remove your hard disk jumper & u r hard will be slave PLACETHE JUMPER IN THE MASTER AT FIRST POSITION AND REMOVE ...
...maxtor need jumper settings for maxtor hard drive,,model 91362u3,,13 gb,,want to make slave out of it no jumpers = slave FAQ here ...
...maxtor hardrive,13 gig,,,would like to make it into a slave,,it has two jumpers on it now,,how can i make it a slave thank you,,[email protected] If one of the jumpers shorts two pins and the ...
...jumper settings are for a Maxtor harddrive. I want to make it a slave in another system. I just need to know where the jumpers need to be placed usualy its just one jumper if no jumper on maxtors ...
...for slave should be no jumper at all. But in case I am mistaken, here are all the jumper setups for Maxtor drives, choose the one that looks like your setup and then choose the correct Slave
Question about Hard Drive
...maxtor hard drive 92720u8 from an old Hewlett P, manufatured 8/16/99, with no jumper diagram. I want this drive to be a slave on my newer pc. The current set up has two jumpers, one x and one o, like ...
Question about DiamondMax 80 (96147H6) 61.4 GB Hard Drive
jumper settings for a maxtor N256 master with slave I'm trying to get the jumper settings for a maxtor N256 (model 96147H6) that I want to use as a master with a samsung SV1204H as a slave. I have the
...jumper settings for maxtor n256 model 96147h6 i wish to run it as a slave pls help. thx For use as slave there is no jumper connected. (Master on/slave off0 The jumper settings are listed on the top ...
Question about DiamondMax Plus 9 160 GB Hard Drive
...the jumper blocks plugged in wrongI i have To use the WD 800 as a master there must be no jumper attached to it.The maxtor has a diagram for the jumper and it MUST be set to slave not cable
gig hello go to this link.. it will illustrate jumper setting http://sysdoc.doors.ch/MAXTOR/diamondmax_30_vl_ultra_ata_66_quick_specs.pdf This link should help. Maxtor Basic jumper settings: Good luck
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions