Questions & Answers for: juki ddl 8700 jammed

Error code E004 and E003 on JUKI LU-1510N-7 and then the machine jams. I have to shut it off for a few minutes and then turn it on and play around with the hand wheel to get the needle to move. HI ...

Cannon insert needle-assembly seems jammed My needle fell out so I am trying to replace it.nit simply will not go up into the needle hole. I am sure the foot is down and the assembly is turned to the ...

...ddl 8700, there is a thread caught in the hook mechanism. It's jammed, can't figure out how to get everything off to remove the thread. Everything else moves fine when the positioning finger is off, ...

the needle broke while sewing and the bobbin picked up lots of thread after a struggle the thread n bobbin came out but now the wheel doesn't turn you have thread in your bobbin case. try spraying wd ...

jammed and needle bar will not move.no thread wrapped anywhere,hand wheel won't raise the bar either 1. Remove the needle and bobbin assemble completely. 2 Try to move the hand wheel - forcefully if ...

...DDL-8700/7 does not equipped with needle feed. for your problem please check back tack solenoid open and close when you make back tack ( sometimes it was jammed and need to move by hand ). best ...

Jammed my new sewing machine with bad nylon thread in bobbin housing. All ready took it apart as much as I can but threads still stuck in machine. Motor runs but will not turn to sew. The machine is ...

Bobbin house is not lined up with the needle for a full turn. How can I fix this? I had a needle slip out of the shaft when I was winding a bobbin, the wheel stopped and needle was jammed between the ...

...Juki DDL 8700 without any fabric to test and the threads got sucked in and now the needle is jammed, when I turn the hand wheel it won't move the needle. I looked below and there was thread stuck in ...