Question about Neptune MAH5500B Front Load Washer
JP4 connector) first. Hi, I looking at my washer this is what i have found. The controller has burned out fuse and i also saw one of the resistors below the fuse on the lower part of the board a brown
...JP4 connector, started the machine on a 6 hour delay and could not hear the motor start at all. Since I heard nothing it seems as if the motor is dead? I thought perhaps that when I had started the ...
Question about Neptune MAH5500B Front Load Washer
...jp4 connector located? maytag neptune washers do have a motor problem and they have a kit to replace the motor and motor controller. when the motor fails, it wont wash or spin. most units have a 5 ...
Question about Neptune MAH6500A Front Load Washer
...jp4 connector if the unit tumbles on it's own then the motor controller is fine but if it does not then you have a bad motor control board. Check it out and let me know. also there is a fuse on that ...
jp4 connector off of the motor control board down bellow i believe it has 4-5 five wires on it. if the unit tumbles on it's own then the motor controller is fine but if it does not then you have a bad
Question about Neptune FAV6800AW Top Load Washer
JP4 Connector from the Motor Control Board * Reconnect Power * Go into Service Mode (press Enviro Plus + Spin Only keys for 3 secs) * Access Board Output test (press Delicates) -- displays shows "ot"
Question about Neptune FAV6800AW Top Load Washer
...JP4 1-2, 4-5 2-3, 5-6* Audio Line-in Source - AMC connector Audio Line-in Source - Line-in connector JPX1 1-2 2-3* CPU Type - AMD K6S-300 CPU Type - Other CPUs SW3-B1 On* OFF AMD K65-300 Voltage ...
jp4 connector? where is the jp4 connector on the motor control board of the maytag neptune TL washer? Blue,Red Yellow and two White wires on the connector. It.s not labled on the Control Board or Plug
Question about MAH6700AWW Neptune Front-Load Washer
...JP4 connector on the motor control board. Set the timer dial into the delay cycle and then press the push to start switch. If the motor operates and the washer goes into a 50 rpm tumble, then the ...
Question about Neptune MAH5500B Front Load Washer
...JP4 harness connector from the board. Plug the washer back in and make sure the door is closed. Press delicates and heavy soil 3 seconds to activate the service mode. Now press the rinse key. Make ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions