jl audio E6450 cutting out I just installed a jl audio E6450 w/2 10w3v3 subs and as soon as I turned it up she goes into protective mode why? Now I installed it myself, but I used all JL audio install
jl audio 250/1 amp it powers up but no sound comes out i have changed the rc cables and checked the wireing on the subs and they r good but the protect light is not on tho only light that is on is the
...JL amp and it stopped putting out i have a 250 JL amp and it stopped putting out sound. it never smoked and none of the protection lights are on. although the power light is ground, false power ...
...jl audio 12w3-d6 into a 4 ohms when the bass hits hard it turns off and my amp goes on protective mode, i have it on a sony explod 1200 watts 4 ohms..... i dont have the jl 12w3v2-d6 i have the older ...
...JL Audio W3v2 2 ohms to a mono JL Audio 500.1 amp and the subs will not work. I have the subs wired in a series. I then hooked them up to my friends amp and the subs worked. Any ideas? try one at a ...
JL audio dealer. It's going to cost some cash unless you have a warranty on it and it was installed by a liscensed technician. ive got a amp called xplod 450wots and its over heating but all the wires
Question about 500/1 Car Audio Amplifier
...jl audio 1400d amplifier stays in protective mode? My JL Audio e1400d amplifier wont work. The normal green power light will come on but so does the red protective light indicating there is a problem ...
Question about 500/1 Car Audio Amplifier
What can I do when my amp goes into protect mode? A6450 class a/b Jl audio Check your speakers wiring to make sure they are not touching. This will make your amp go in protection mode.
Question about 500/1 Car Audio Amplifier
JL AUDIO JX 1000.1D protect light comes on some damage to rca's but no visual loose connections ...help You will need to open it up to see if anything damaged. That does not look good at all from the ...
Question about 500/1 Car Audio Amplifier
...jl audio jx500-1d went on protection mode and already disconnect every cable to it and try it again but same thing goes to protection mode Sounds like you either shorted something out or overloaded ...
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions