jet nozzle does just prize off, and normally there is enough spare on the hoses to pull then out a little. The nozzle is attached to a small filter, you can separate them easily by pulling them apart.
Question about Corrosion Resistant Shallow Well Jet Pump 1/2HP, 8GPM
...the injector nozzle is plugged. This nozzle is directly inside the influent line on single line jets and down in the well on two-line jets. I'm assuming you have it primed correctly. If this ...
...nozzle has holes in it and the fuel is sucked through the main jet and out the holes to mix with the rushing air as the needle raises. Beyond that I haven't got a clue. Please rate this solution. ...
...jet nozzle is clogged- causing the engine to starve for fuel at high revs. Remove carb, take the bowl off the bottom and locate the main jet. The main jet is screwed into the main nozzle, which you ...
Question about 2002 EXC 200 GS
jet and nozzle are the areas to pay attention to. The main jet screws into the carb in the same spot that the float bowl screw goes into. The nozzle sits above that and if you tap the carb (carefully)
Question about 2007 Camry
...nozzle jet in 2007 Toyota Camry One of the nozzle is not spraying properly and i want to replace/repair the nozzle jet. please let me know how to remove the existing jet and clean the jet. Before you ...
Question about 13 HP Engine w/electric start - GX 390 QXE GX390QXE
...jet and nozzle first shut fuel off,remove the bottom bolt of fuel bowl and pull away,inside the stem where bolt came out of are the jet and nozzle using a #2 screwdriver insert in the stem and ...
Question about 13 HP Engine w/electric start - GX 390 QXE GX390QXE
...jet? Is the nozzle adjustable? The spray is now only producing a wide angled fine mist and won't produce a focused jet which I can use to clean a brick pation. Does anyone have thoughts about whether ...
Question about 13 HP Engine w/electric start - GX 390 QXE GX390QXE
...jet nozzle has stopped working. There is no rotation of jet. Also it just stared pulsing on one wand, but works fine with the root jet wand. Thanks the rotating nozzle is clear and that is why it is ...
Question about 13 HP Engine w/electric start - GX 390 QXE GX390QXE
jet nozzles have water coming out The nozzles have probably become clogged with sediment over time. Soak shower head in CLR for 3 - 5 minutes to dissolve sediment. Run water. If nozzles still not free
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions