...jeep tj has drive train noise between 80-100km as your driving at 80km-100km there's ahuming or growling noise sounds like pion bearing but i've been told its not pion bearing also u joints appear to ...
...70-85 ft lb Ring gear bolts 70-85 ft lb Pinion bearing preload if using original bearings 8-14 lb-in, if installing new bearings 16-28 lb-in The rear end axle nut torque ratio for a 2018 Jeep ...
...pinion bearing, fresh lub, replaced race and sleave. noise is still there. while drive shaft is not connected the pinion shaft it is locking up in the differential. only in forward not in reverse. ...
...BEARING ON DANA 35 AND NEED SOME TIPS If you are going to change one of the pinion bearings you really need to replace both since you will have the pinion shaft out anyway. At the same time you will ...
jeep rear ends are loud but this one is louder than normal. It sounds more like tire noise than anything, but I'm not sure. Where should I start or should I not even worry about it. rear wheel bearing
...Jeep Grand Cherokee. I suspect it is the rear wheel bearing. Is it easy to replace? I have done it on Ford truck before. It has 80000 miles on it. YEP CHRYSLER, FORD, CHEVROLET REPLACING REAR WHEEL ...
Question about 1995 Grand Cherokee
Jeep Grand Cherokee at parking lot speed I have a chatter coming from the diff. when I let off the accelerator, I have replaced the fluid with Royal Purple which says I DON'T have a modifier. Is a
...jeep grand Cherokee. what do you suggest. Leaking by axles or input shaft (driveshaft),if it is the pinion change the seal, make a dot mark with a punch on the nut and the pinion before removing the ...
Question about 1997 Grand Cherokee
...pinion nut on 1997 jeep grand Cherokee limited with a5.2 v8 want to tighten pinion nut rear has started whining at certain times. the rear axle front pinion DANA 44 or AMC? the answer is not simple , ...
Question about 1997 Grand Cherokee
...rear end bearings on this jeep There will be one bearing pressed on each axle as well as two carrier bearings attached to the inner diff assembly. There will be two pinion bearings in the diff as ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions