Questions & Answers for: jeep j20 specs

when you bump the ignition the starter stays engaged until the siloniod has the top two wires taken off The solonoid is sticking, either have repaired or replace starter

I GOT NOT POWER IN COIL SO THE JEEP WONT START Check the ignition fuse and the ballast resisitor. Most Jeeps had these on the firewall. Looks like a square knife sharpening stone about 3" long with ...

...Jeep J20 engine or trans.? lost the operator guide? ah it not a GC. seen on all jeep dealer parts pages. part ID ...

whats the torque spec on j20 connecting rod bearing bolts J20, that is in FSM and at alldata.com and and suzuki pit stop plus. i looked and saw 33 foot/pounds. mains are 10mm: 43.5 ft. lbs. 8mm: 19.5 ...

...jeep j20 Have power on all three wires at headlamp at the same time Sounds like you have a bad earth. Steven I posted a answer but I don't think you followed the instructions I gave you. I added ...

...jeep j20 have power at all three wires at headlamp at same time. Of course headlamps don't work The quickest way to repair the problem is unplug the plug from the headlight. Then hook up a test light ...

how to remove oil pump which engine? surely you know whats there, doing such radial work. and why? do post why. id bet its not the pump, wana bet? G16B engine J20 H25, h27 or larger? each is very ...

...specs. no country stated (we are usa) the uSA tracker ended in 2004. NO JOB stated, New HEAD, NEW CAM, or? watch out for wrong answers here,...... some never seen a suzuki ever. J20 no year stated? ...

...J20 has 1 spring tensioner,it can and be too loose, allowing belts to beat them selves to death.(spring can go week or break ,i man handle them ,yup feels right. (a skill that must be demonstated) ok ...

...j20 head bolt torque Head tightening procedure and torque specs: For M6 bolts: Step 1: 11 Nm (1.1 kg·m, 8.0 ft·lb) For M10 bolts: Step 1: 52 Nm; 5.2 kg·m; 38.0 ft·lb Step 2: 82 Nm; 8.2 kg·m; 59.2 ...