...jbl gto7001 mono amp. direct from harmon kardon.. the amp does not power off when the ignition is turned off.. is this normal or is the amp defective? will it drain my battery if i leave it be? Hello ...
Question about GTO Series GTO1004D Subwoofer - 10-Inch Dual 4 Ohms ¿ Polypropylene Cone ¿ Nitrile-Butylene (NBR... Car Speaker
Amp is putting itself in protection mode. My gto7001 amp is putting itself in protection mode. It will turn on for about 30 seconds and then shut off. I would check to see if you have a secure ground ...
i have a JBL GTO 7001, it switches in an out of protection mode. i pulled out the amp, an noticed that the positive wire from the speaker was pulled out. so i disconnected the power scorce an ...
MY GTO 7001 HAS ITS LIGHT WORKING, BUT NO POWER COMING OUT. Make sure your rca jacks are plugged into both your headunit and amp. Also make sure that the amps filters are set so that the amp plays all
...JBL GTO7001 amp JBL do not suggest bridging this amplifier. As it is a mono block, the "stereo outputs that are on the amplifier go to the same contacts inside", so effectively both Left and Right ...
Hi ,how can i connect my two 10 inch JBL double voice 4 ohms coils to my jbl gto 7001 amp It is confusing with the 4 channels it gives you but you really only need to connect it to one or the other ...
gto 7001 is it 2 ohm stable when bridged It is 2 ohm stable. I have mine at 1.33 ohms and it still plays. It is 700 watts rms at 2 ohms per one channel.
Question about GTO7001 Car Amp
...jbl gto7001 amp to put out 2 ohms to a dual voice coil sub The wiring of the amp is not what makes it 2ohm or 4ohm, it is the resistive load of the sub, The issue is that your sub, assuming it is the ...
my power is 0.93 A hou manny volt iss that wand to make it work inn my home Perhaps make it more Clear then i can help u!
Usually answered in minutes!
687 Questions
481 Questions
236 Questions
236 Questions
240 Questions