Questions & Answers for: jandy water temp sensor short

Jandy Lite2 125,000 btu pool heater and there seems to be a problem. The pump kicks on like it should and the heater fires but it only stays lit for about 15 seconds, then it shuts off. After 3 of the

...water temperature sensor has gone bad. These will cost around $60-80 retail, unless you buy Jandy OEM, then you will be paying well over a $100.00. But you can also use a Jandy, Goldline, or Pentair ...

...i cant get it to work it just blinks check to see if water temp sensor shorted remove to black wires from control board if it quits bad temp sensor if it doesnt bad display board need new display ...

water sensor short keeps displaying on my pool??? replace water temp sensor for aqualink

Water temp short reads on control pad can this be related to the spa light The problem is most likely a shorted temperature sensor. I hope this helps.

...water temp sensor attached to the plumbing is bad or the wire to it could be damaged. Try replacing the temp sensor. The diagram inside the control panel door tells you which wires to remove from the ...

...water temp of 88 degrees. Resistance drops as temp rises. A "short" will give you the same result as just holding the two test leads together. Having the heater idle for a few weeks should not have ...

water temp short replace temp sensor

Water temp short Is this a sensor and where do you find it to replace water temp sensor on system is connected to the pipe coming from the pump outlet goes to numbers 5 and 6 on long plug on Bezel ...

Our Aqualink RS4 panel says water sensor shorted. What does that mean? replace the water temp sensor that's the one that goes to the plumbing