Question about Aqualink - Rs24 One Touch Pool / Spa Combination Control System
Jandy Aqualink - Rs, button control red lites on contriol panel All button lites tyrned red with a reading of 6700 rev C Pool filter system continues to function with start and end times Thanks 863 ...
...Jandy AE 2500T heat pump says "high refridgerant pressure". What does that mean and what do I do about it? Thanks, Norm I was able to find the manual online which had the solution in the ...
Question about AquaLink RS OneTouch RS8 Pool or Spa Only (Pump Heater + 8 Aux) RSP8 ()
...Troubleshooting Guide from Jandy. I also have a AquaRite Clorinator and have checked the wiring to the main power panel. The 4 pin connector also appears to be okay, along with the correct voltage ...
How much time would a technician need to replace a high limit switch on a Jandy Pool Heater? Thank you for posting your question here on Fixya.com. It should only take a few minutes to actually ...
Question about LAARS LX250 - PROPANE, DIGITAL READ-OUT, LOW NOX
troubleshoot jandy lx250 air flow switch if fan doesn't go on that will show up make sure safety circuit is ok
Question about Lite 2 Natural Gas Pilot Light Heater
...troubleshooting to determine that my igniter on my Jandy Lite 2 is fried..(open circuit when disconnected). So how do I remove the thing...am I supposed to disconnect the gas to remove the entire ...
Question about Lite 2 Natural Gas Pilot Light Heater
...Jandy 2Hp Pool Pump stopped working Is there troubleshooting I can do to find out if it needs to be repaired or relacedD see if there is voltage going to switch then to pump if voltage at pump bad ...
Question about LX 400P Lo-NOx, 400,000 BTU Heater Part LX400P-L"
how do i correct a "high limit switch circuit is open" code My pool heater (Jandy model LX400P-L) doesn't heat up the pool. The panel displays a code "HI LIM SW", a fault description that states a ...
Question about LX 400P Lo-NOx, 400,000 BTU Heater Part LX400P-L"
Jandy Aqualink RS One Touch is lighted up backlight and showing black lines with a yellow light. Is the display bad? Not sure how to troubleshoot. My Jandy Aqualink RS One Touch display is showing ...
Question about LX 400P Lo-NOx, 400,000 BTU Heater Part LX400P-L"
jandy ji 8000. need to troubleshoot why Aux 1 light goes on and off (blinks) and interferes with display. Will only show date, no time or temp. I am now making more than 350 dollars per day by working
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions