Questions & Answers for: jandy thermocouple

pilot will lite but burners will not kick on - Jandy lite 2 400,000BTU pool heater Me too.. was able to fire it up by tinkering with the switch that goes from "Pilot" to "On", but doesn't always work.

...Jandy heater we replace the thurocup part but it still won't work. [email protected] If you replaced the thermocouple, and followed instructions on relighting to the letter and you have good gas ...

pilot light is lit, burner will not come on pilot light is lit but the burner will not come on. The thermocouple must be in the flame of the pilot and producing a signal to the gas valve. Also check ...

I have a Jandy LITE2 LG325. Only two years old. I have a Jandy LITE2 LG325. Only two years old. Pilot lights but can't fire burners. Any suggestions? Does the pilot light stay light? Or light then go ...

my heaters pilot wont stay on and ive replaced the My heaters pilot wont stay on and ive replaced the thermocoupler and pilot assembly and replaced the gas valve and it still wont stay lit what could ...

I have a Jandy LT low NOx heater, about 3 years old. It worked once this season, but now I turn it on, power light lights up, but nothing happens (no air/gas, etc.). Gas lines are on and water is ...

when main burner comes on 20 secs later pilot gos out gas valve then shuts down Remove the burner tray, Clean pilot orifice, make sure it is screwed in and in the right position, and replace the ...

...Jandy Milavolt. The Thermacouple will not keep the gas valve open when the pilot is lit. As soon as I release the pilot valve the flame go out. I am assuming the thermacouple is bad but I don't ...

...Jandy Lite 2. We just started it up for the season - pilot light is lit, unit is on and thermostat is turned all the way up but the burners will not start up? Any ideas on trouble shooting? sounds ...

...Where can I obtain a replacement? possibly the heater manufacturer . pool distributor that sells ...