Question about Lite 2 Natural Gas Pilot Light Heater
...my pool opened, the heater was shutdown for winter properly but wont start. Checked everything. Clicks like it wants to start then immediatley flashes fl 4 check pressure switch or copper line to ...
Question about Laars Lite 2 Pool Heater 250,000 Btu / Natural Gas
Jandy heater not starting panel is saying service, under pool it reads FL, and the number 4 FL 4 is igniter failure. 1. check the fuses on igniter wire as well as the wires. 2. replace igniter
...Jandy Lite 2 pool heater FL 4 error heater clikcs like it's going to fire up, but it doesn't then FL 4 flashes I believe you may have a draft restriction and this may stop the start up diagnostics. ...
Question about Lite 2 Natural Gas Pilot Light Heater
Jandy Lite 2 I have two Jandy Lite 2 LP heaters. One was on pool the other on spa. During the winter the heater on the spa froze so I swapped heaters. When I tried to start the heater, I got code FL 4
...2 error code on my jandy lite2. I changed the flame sensor and still get same error message Look at the list of codes inside the cover of the heater. Your owners manual should have a complete remede ...
Question about Lite 2 Natural Gas Pilot Light Heater
JANDY LITE2 LJ HAS A FL-2 CODE WHEN HEATER STARTS HEATER JANDY LITE2LJ WORKED BEGINING OF SEASON A MONTH LATER I GET THIS SERVICE CODE OF FL-2 CODE HEATER STARTS TO CYCLE IGNITION GLOWS BUT NO FLAMES ...
Question about Lite 2 Natural Gas Pilot Light Heater
FL 4 code Hot surface igniter problem on Jandy Lite 2 - FixYa check the fuses from the red wires if blown replace if ok replace ignitor
jandy lit 2 heater error fl 6 Does error FL 6 always mean that the control board is bad - or could it be another problem?? gas signal being sent to gas valve not by controller either stuck gas valve ...
...Jandy Lite 2. I'd like, if at all possible, to fix it myself because it's Memorial Day weekend and we'd like to have our pool heated for a gathering on Sunday. Anyone able to ...
Question about Lite 2 Natural Gas Pilot Light Heater
My LJ250N keeps blowing both inline fuses, then I get an FL 4 error code. I replaced both the ignitor and flame sensor rod, what else could cause this? replace the circ board and high voltage chip
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions