Question about Acer Computers & Internet
...jack is loosing its spring, this spring action is what holds tension on the shaft of the pluug. The center pin that conducts the positive charge tends to break its solder point and therfore the chrge ...
...Shaft pully, Alternator and tensioner were on,put the belt over the AC pully. Back on top, Remove the tension and finish the job by installing the belt over the WP & PS. I hope this helps. The ...
...remove brake tension nut, remove bolt on frame bar, loosen bolts on shaft clamp after removing nut on shaft then knock shaft out . must have bike on jack to clear ground when working tire loose
...shaft wheel and note the direction that the arrow is pointing, the arrow should be pointing straight up IN RELATION TO THE ENGINE not the earth. If it is not, you will need to manually rotate the ...
...shaft-4-cylinder Odyssey Install the upper timing cover and the valve cover. Be sure the seals are properly seated. Install the side engine mount. Tighten the through-bolt to 47 ft. lbs. (64 Nm). ...
Question about New Genuine Polaris Snowmobile Accessories / X Treme Sidecut / Out of Bound
why does 1997 500 indy asilate on take off is it the clutch YES IT COULD BE A CLUTCH, JACK SHAFT OR DRIVE SHAFT BEARINGS. ALSO SHECK YOUR CHAIN AND TRACK TENSION
Question about New Genuine Polaris Snowmobile Accessories / X Treme Sidecut / Out of Bound
the gears are skipping but the gears are all good CHECK YOUR JACK SHAFT AND DRIVE SHAFT BEARINGS AND CHECK YOUR CHAIN TENSION
jack and the A arm. Spray area with WD 40 remove the nut from the ball joint. Strike the spindle with a hammer (single blow at a time) in the area were the tapered shaft of the ball joint goes through
...shaft has moved then you will need to find top dead center or TDC I will explain this a little later). step 1 jack the car up and support with jack stands (for transverse mounted FWD engines remove ...
...shaft. To break it loose get a large screw driver and from under the car in front hit the inboard joint hard several times until it over comes the clip ring. Remember... always use jack stands when ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions