Questions & Answers for: isuzu rodeo removable top remove

...isuzu rodeo How do you replace the alternator on a 97 isuzu rodeo from Yahoo answers The alternator is located on the passenger side of the motor at the bottom. There is a bracket attached to the ...

Ad

...isuzu rodeo 4cyl 2.3l??? I have removed the wires, but I can't remove the housing over the plug. It seems that it is connected or pushes against part of the fuel injector? I can't believe I am the ...

Ad

Isuzu Rodeo I need advice on installing a new fuel pump on a 1992 Isuzu Rodeo!!! fuel tank has to be removed to remove fuel pump sender unit. make sure tank is near empty so its not as heavy to remove

Question about 1994 Rodeo

2 Answers

...Isuzu Rodeo I need to change the crank sensor in my 94 Isuzu Rodeo. But I have no clue where it's located. Any help? it's on the bottom of the motor, towards the back on the passenger side. It has a ...

...isuzu rodeo engine pan has two plugs in it. start vehicle, run through gears a couple of times then while engine running with vehicle on flat ground remove fill plug and top up until oil trickles

isuzu rodeo how to remove ac evap coil from 2001 isuzu rodeo You can try accessing it from behind the glovebox assembly, depending on the engine/trim combination you have, but you may have to pull the

...isuzu rodeo 2000, engine 3.2 liters no dip stick u have to go under truck theres 2 drain plugs u remove the top start car and if fluid comes out it full if not u need to add with pump same plug ...

Question about 1997 Rodeo

1 Answer

...Isuzu Rodeo? How do I go about cleaning the screen? Or replacing it? The oilpump is located inside the oilpan, there are two parts to the pan, you should be able to clean the strainer by dropping the ...

...isuzu rodeo I just replaced the antenna on our 02 rodeo. No need to remove radio or anything in dash. This is how I did it. First you will need access to back of fender, enough room for your hand. ...

Question about 2001 Rodeo

1 Answer

...Isuzu Rodeo 3.2L v6 is located on the top of the engine under the upper intake manifold. In order to replace it you will have to depressurize the fuel system by running the engine with the fuel pump ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...