Questions & Answers for: iron working quits

Shot of Steam The shot of steam button on my iron has quit working though steam does come out of the bottom while ironing. Help? take it down and clean, it is clogged up.good luck.

...working on my iron, actually once in a great while it will steam but only for a few seconds then quits again. Is there any suggestions to fixing it? A mineral buildup from your water may be blocking ...

iron quits working: Buy a new one! These days, irons can be purchased cheaply enough that it is WELL worth the money. Not just for the convenience, but for the safety issues. This is an appliance that

Iron quit working in less than 1 year. I purchased a Shark Iron from Target store about 2 years ago. the iron caught on fire and Target did nothing about replaceing it . I notified the Shark company ...

...working My broun iron (model SI6285) quit working. The power light is off. It worked intermitently before it shut down for good. I opened the back cover and pulled out a rubber molded module, which I ...

iron casing. Do you think there is a replacement cord? Also, would the cord cause it to quit working like that? It is probably an intermittent cord connection next to the strain relief. You can simply

...to troubleshoot your iron and figure out what is wrong with it. Electric Iron not Heating Up or not Working Right http://www.fixya.com/support/r5300202-electric_iron_not_heating_up_or_not ...

My Rowenta expert DG8030 QUIT STEAMING. WHAT DO I DO. Has it been dropped or did it just quit? There 's a leaked capacitor in the circuit board. You just have to replace it and it works again. Please ...

...iron is in good working condition. How do I re-glue the sole plate. Which glue do I use? Just cleaned the part the sole attaches to with a cloth.nthere was quite a bit of scale. bend all the sides ...

...working properly yesterday after being just fine the day before. It did work though, when I connected the ground What happened?clamp to the piece of iron I clamped the ground to the iron I wanted to ...