Questions & Answers for: intex spa problems

...Intex Pure Bubble Spa. The filters do not have any suction. Are they supposed to? If so how much? I do not feel anything. For a test only, remove filters and see if you feel anything against the ...

...Intex Pure Spa" inflatable spa. It shut itself off. when I push restart it starts up then in about 10 sec an "E" comes up on the screen and it beeps. What can I do to reset and fix the err It's 4mo. ...

...intex 200 gal spa Sensing problem with sufficient water flow! • Ensure the unit is plugged and switch on.• Ensure the outlet cover grid is clean and free from obstructions.• Clean or replace the ...

...intex corp to get an o ring for pure spa, but they are out of stock. Wondering if anyone knew of retailer of intex who sold parts funny,they have them now, Spa Control Station Air Inlet Ring ...

...Intex spa pump will not turn on does the unit power up if not check and test the ground fault safety plug they can fail --if powers up and pump not working then the your problem is most likely the ...

spa intex saltwatersystem problem heater reads wrong 2 secounds after right read When I plug in my intex saltwatersystem spa the display reads 18 degrees Celsius at first and then almost immediately ...

intex pump (56417) starts runs for 2 mins then shuts down then starts again after 2 mins an so on can you help ? if its the spa possible the housing/cover on the pump is deteriorating or ceramic shaft

...intex spa is reading 999 and won't cut on. This happened after a power outage are you sure its not e99 water temp sensor because their is no 999 code for intex -----------turn off at gfi and unplug ...

...intex Pure SPA, getting code E 97, how can I fix it? E 97 is an error code that indicates a dry fire protection system has been activated in your Intex Pure SPA. This means that the spa has sensed ...

Intex Pure Spa reads code E97. How do I correct this please? Spa was emptied for a few weeks. I did just fill it with water above the minimum line and added the salt... Can I run only the filters to ...