Questions & Answers for: installing distributor

...installing distributor , visually inspect distributor . Inspect the O-ring. It should fit tightly and be free of cuts. The drive gear should be free of nicks, cracks and excessive wear. Rotate ...

how do you replace the distributor on an 89 jeep wrangler YJ Jeep Wrangler/YJ 1987-1995 Repair Guide DISTRIBUITOR REMOVAL & INSTALLATION 2.5L Engine 1987-90 VEHICLES See Figures 1, 2, 3 and 4 Fig.

How do you change the distributor on a 1997 Nissan pick-up? Remove the two (2) screws securing the distributor cap and remove the cap. Remove the bolt securing the distributor. Disconnect the crank ...

...on after installing the distributor, and a DTC P1345 is found, the distributor has been installed incorrectly. Repeat Installation Procedure 2 for proper distributor installation  hope this ...

just wondering if you have a breakdown diagram for a 1992 dodge colt 1.5l distributer I do not have a breakdown diagram for a distributor, but just the firing orders and description of ignition system

97 dodge stratus 2.5 car turns over but does not have spark. There is fuel. I replaced the ECM crankshaft position sensor. I would start with the rotor and cap. I just worked on one and it was the ...

REMOVE DISTRIBUTOR FOR A 1996 GMC JIMMY Check this procedure... Disconnect the negative battery cable. If necessary, remove the air cleaner. Tag and remove the spark plug wires and the coil leads from

...installing distributor, visually inspect distributor. Inspect O-ring. It should fit tightly and be free of cuts. The drive gear should be free of nicks, cracks and excessive wear. Rotate distributor ...

...installing a distributor 180 degrees out of time. The distributor must be aligned with the camshaft drive to seat the distributor in the engine block or cylinder head. Rotate the distributor a small ...

sequence and specifications when installing fasteners in order to avoid damage to parts and systems. Install the distributor clamp bolt. Tighten Tighten the distributor clamp bolt to 25 N·m (18 lb ft)