Question about Quincy 17 - Gallon Air Compressor with 5.5 Hp - G15H17PC3B
...Install push rod guide on Honda 5.5 160GX Motor? I have worked on many gx160 engines and have found that the most economical way to repair an engine with worn valves/guides is to replace the complete ...
Question about Quincy 17 - Gallon Air Compressor with 5.5 Hp - G15H17PC3B
...tappet guide plate retainer tabs are toward the rear of the cylinder head , and the valve tappet guide plate tabs are toward the front of the cylinder head. To install, reverse the removal
Question about Quincy 17 - Gallon Air Compressor with 5.5 Hp - G15H17PC3B
...to replace the head but a new valve guide may be called for. That will require the proper tool for installing it, so it runs in line with the valve
...running temperature. most likely worn valve guides and probably dry cracked and fallen off valve stem seals you may get lucky with just replacing valve stem seals but may need guides installed in ...
Question about & Posi-Temp Single Handle Shower Or Tub Valve
...3570 shower valve. I need the rough plumbing instructions. call moen they will send it out usually at no cost ...
...valve guide seals; all fine but probably not needed. When the piston was changed, did you run a cylinder hone in the bore to check for distorted cylinder walls? Was the old piston seized up at any ...
...guide. On the last page of the guide, the exploded diagram shows where the valve is located. Here is the link: ...
Question about 2005 CRF 230 F
...VALVE GUIDES CAN BE INSTALLED. CAN VALVE GUIDES BE INSTALLED?WHAT IS THE ALLOWABLE PLAY ON THE VALVE STEMS? yeah they can be, and are supposed to be. yeah you better put valve guides in it. you need ...
Question about 2005 CRF 230 F
...valve is new. I would suspect, unfortunately, that you have a bad head gasket. incorrect rebuild --can be anything from incorrect gasket install -loose or not correct torque on bolts --damage to a ...
Question about 2005 CRF 230 F
...valve guides are fully seated in the head. Compare the exposed length of the exhaust guide to the intake guide. They should be the same.
If the engine cooling fins are not kept clear and the ...
Usually answered in minutes!
317 Questions
162 Questions
122 Questions