Questions & Answers for: install resistor blower motor 2004

...of knob. If the knob wiil be turn on any position air-con swichon as well Check the Resistor component in between the wiring and the blower motor. it has a plug and it controls the blowers speed

blower motor fan,inside the car,look for a blown fuse,or a bad fan relay.The blower motor relay could be mounted near the blower motor,or in the relay box,look for the lables to guide you to it.If the

...side dash right by the transmission hump there is a connector that goes into the duct work that is probable shorted out and supplies ground to one side of the blower motor. new part costs about $ ...

...2004 Volvo S40. The blower for the heater and A/C stopped working. I have the part(#30864189) but I can't find where it goes. Engine compartment? Under the Dash? etc. Please help. Thanks, -Mike IT ...

...resistor module, this is located on the heaterbox next to blowermotor, i would start there if all fuses are good, the other thing you can do to test motor before replacing the part is disconnect ...

...blower and resistor? That's what it sounds like to me. If the blower is making noise than the only thing you can do is replace it. Blower resistors typically operate by dropping voltage through a set ...

the resistor is bad, not the blower motor...you may need to unplug the blower motor until you find and install the resistor...your parts store can confirm the right part, and location. Hope this helps

...blower motor and resistor last. I had one replaced at around 120k miles and now it need to be replaced again at 220k miles? the motor will last just about for ever but the resistors are prone to ...

...resistor) will shut off blower if the ... the current to blower(voltage level to blower) is controlled by the ECC control unit. ... Hook the negative side of the car battery (or other 12 V source) to ...

...blower fan resistor, and now the blower motor quit. Is there something wrong with the temperature control? The problem was the motor. Replace the blower motor and resister and it should be fine. If ...