...are available but are a bit tricky to install. DickyO My IBM Wheelwriter III does not print the letters. I have replaced the ribbon but still no letters. Please help. Thanks. replace hammer ...
...HAMMER STOPPED HITTING THE KEYS. IS THERE A RE-SET PROCEDURE, OR AM I LOOKING AT A SIMPLE MECHANICAL REPAIR TO REPLACE A DEFECTIVE PART? If this a wheelwriter the platic cap on the orint solenoid is ...
...print solenoid is under the ribbon just inside the L. printer side frame. When you type with the ribbon off you should see the plunger go in and out (a very short movement) on the back of the plunger ...
Question about Wheelwriter 30 Typewriter
...print out. the hammer solenoid moves very lightly The plastic cap on the silenoid plunger is probably broken, thet are availabe but a little rticky to install. We sell them for 15.00 including ...
Question about Wheelwriter 30 Typewriter
...print still after replacing ribbon and correction tape. There's a small cap on the solenoid that pushes the hammer, this cap wears out and the solenoid cannot push anymore. Cheap part, always wears ...
...install a new print hammer solenoid? I doubt that you need a solenoid. Probably the plastic cap is broken. We sell them with ninstructions and shipping for 20.00. DickyO Cleveland Business Machines ...
...hammer not making contact with ribbon. New ribbon, new printwheel. Please help! The plastic print solenoid cap is probably broken. We sell them with installation instructions and shipping for 20.00. ...
print wheel hammer not hitting print wheel when typing. Your problem is probably the print solenoid either not firing or the cap that is on the end of it has broken off. Usually the cap is broken and ...
...print solenoid look like where is it located and what does it look like? The best way to find what you are looking for is to look at your printwheel. Right in the middle of the carriage there is a ...
...print solenoid cap have the new cap but don't know how to get the solenoid out to put the cap back on The best way to find what you are looking for is to look at your printwheel. Right in the middle ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions