Questions & Answers for: install a knock sensor

Question about 2005 Sebring Conv

2 Answers

Install knock sensor. Tighten knock sensor to 10 Nm (7 ft. lbs.) torque. Over or under tightening effects knock sensor performance, possibly causing improper spark control. Attach electrical connector

Ad

knock sensor. Reverse the procedures to install the part. I believe this car takes premium gas. If you are using regular it will knock so try premium and while you at it, add a can of injector cleaner

Ad

...Install: Attach the knock sensor (KS) to the engine block. Tighten the bolt to 18 ft lbs (25 Nm). Connect the knock sensor (KS) connector. Install the left front wheelhouse liner and wheel. Fully ...

...PrecautionsInstall the knock sensors. Tighten Tighten the sensor to 20 N.m (15 lb ft) Connect the knock sensor electrical connectors. Push down on the rubber covers. Install the intake

Question about 2004 Yukon

2 Answers

...knock sensor. Reverse the procedures to install the part. 15 ft.lbs.torque hope this helps.Thank You for using fixya..iluv2fish.. Ray.. Knock sensor is located on side of engine block screwed into a ...

Question about 1998 SL

1 Answer

Install the knock sensor and attachment bolt with the larger metal contact area toward the engine block. Thanks. Keep updated for any more query. You can rate this solution and show your appreciation

...install the part. A defective knock sensor may cause engine detonation or reduced spark advance and fuel economy. When a knock sensor is removed and replaced, the sensor must be tightened to its ...

...Install the knock sensor.TightenTighten the knock sensor to 25 [n-m] (18 lb ft). Connect the knock sensor electrical connector. Reinstall the intake manifold.this is quite a job and i would not ...

resulting in engine detonation. To replace the knock sensor: Disconnect the knock sensor wiring connector. Then, unscrew the sensor. Remove the knock sensor. Reverse the procedures to install the part

...Raise and safely support the vehicle. Remove the intake manifold. Remove the bolt and the Knock Sensor (KS). To install, reverse the removal procedure and tighten mounting bolt to 15ft. lbs. (20

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...