Questions & Answers for: install ignition switch

...key reminder switch screws. Remove the ignition switch screws and remove the ignition switch. Installation To install, reverse the removal procedure. Check for proper operation of the ignition

install the bolt. Tighten the ignition/shifter interlock cable mounting bracket bolt to 4-6 Nm (35-53 lb-in). Connect the ignition switch electrical connector. Install the multi-function switch. Refer

...Install the ignition switch into the actuator. It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the lock cylinder housing ...

...Install the ignition switch pin into the actuator. It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the lock cylinder housing ...

...INSTALL.ignition switch installation for non tilt columns.move the the ignition switch slider to the off unlocked position move the slider all the way down.then back 2 clicks.the remote rod hole in ...

...Install ignition switch lock cylinder by turning it to RUN position. Insert ignition switch lock cylinder into steering column lock cylinder housing. Make sure ignition switch lock cylinder is fully ...

...Install ignition switch mounting screw. Install the interlock cable into the switch assembly. Attach electrical connector to SKREEM Module. Install switch assembly into Instrument Panel. Attach ...

...Install the ignition switch: Position the ignition switch and tighten the screws. Connect the electrical connector. Install the contact reel. Tighten the M5 screws to 44 inch lbs. (5 Nm). Install the ...

...Install the ignition switch bracket. 2.Install the theft deterrent control module. 3.Install the ignition switch bracket screws. NOTE: Refer to Fastener Notice in Service Precautions. Tighten the ...

...Install the ignition switch assembly into the column actuator hole. It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the lock ...