Questions & Answers for: infocus in26+ projector

...projector seesm top be over heating, there is an orange lamp warning light....I've lost the manual, does this mean I need to replace the lamp or is it a tech fault? i found out that the, in26 that i ...

Infocus IN26 Projector Runs fine at sea level but when running at an elevation of 8300 ft it powers down with what appears to be overheating. Specs say should run OK up to 10,000 ft. Not getting much ...

Infocus in26 fan runs continually After power down, the fan runs until the light is solid which indicates the bulb is cool. However the fan never stops. Continuous humming. Hello, The fan does run ...

...infocus in26 projector that has a shadow on one side of the image. i have been told this is indicative of a light tunnel collapse, is this a problem i can repair and if so how do i get the new tunnel ...

InFocus IN26 overheating same as previous poster ... unit works fine for around 1 hour then shuts off with lamp indicator light lit. Lamp only show 142 hours of use. after a reset it works fine for ...

...projector is dead - no light, no fan. bad power supply. you can get the part from an infocus service center, or send it to them to repair. either way, try av solutions in ny. they're really good. ...

...InFocus IN26? And while we're at it, where do I get one? I've already replaced the bulb with a new one (direct from InFocus), reset everything to factory settings, and called InFocus Tech Support, ...

Infocus IN26, the center of the picture just developed a black / grey band that runs vertical through the center of the picture. This happened at the same time something smelled as if it was obviously

Infocus IN26+ - Picture has become very dim and it seemed to get darker realtively quickly, within a week or so. Have tried factory reset and contrast and white balance adjustments with poor results. ...

...Infocus IN26 has less than 900hrs consumption but the resolution is almost blurred. Is the lens kept clean and the optical engine cleaned regularly. Is it used in a smoky atmosphere? problem is in26+ ...