Questions & Answers for: incorrect ribbon message

Incorrect T/C type means that toner cartridge have not good contact with toner chip, is good to clean this chip, or contact inside magine is not good. Change toner cartridge and if that problem remain

...incorrect, yet the same size previuosly had worked. Also, for the printing properties of the X2000+, It should give the option of thermal transfer for printing, yet only gives auotmatic selection and ...

...MESSAGE RIBBON PROBLEM AND RESTARTS FOR A SHORT TIME AGAIN IF I PRESS ON LINE BUTTON. I DO NOT KNOW IF I AM FITTING THE RIBBON CORRECTLY AS I DO NOT HAVE AN INSTRUCTION BOOK.. I WOULD LIKE ADVICE OR ...

...message E-02 came up. Cannot get the printer to do anything now. E-02 comes up every time I switch on. E-02 is an ink cartridge error, possible causes incude faulty ink cartridge chip, incorrectly ...

...incorrect and to install the correct print head". I have turned off the printer several times. I have unplugged the printer twice and waited a few minutes and turned it back on. I still get the above ...

...ribbon cable (J5), and power from the ECU (J6). Verify boot select jumper on the formatter PCB is installed on the bottom two (correct) pins (see photo below) to ensure the unit ?boots? from the ...

...incorrect frequency, it shuts down the shuttle and attempts to restart it. If the shuttle still operates incorrectly after three consecutive attempts, the Printer goes Offline, and the Shuttle Fault ...

...Incorrect Yellow message upon turning on the printer HP2820 The printer would only display messages of functions commonly as ink shortages. For example, color printers with encountering ink shortge ...

...message: NO FLIPPER MODULE - The Flipper is unable to communicate with the flipper module. Ribbon breaks on those older models are usually traced back to only a couple of things. 1. The ribbon-type ...