...IMRC sticks open, but is due to the control box, not sludge. E.g. 3500RPM, go back to idle, IMRC stays open, unplug power to the IMRC box allows it to close freely, but plug in the electical to the ...
...IMRC control circuit is open or shorted to ground IMRC Monitor VREF circuit is open IMRC is damaged or the PCM has failed Most likely not the last one as that would be the last thing to check and I ...
...Control (IMRC), Vacuum ControlRemove E-clip retaining vacuum control linkage to lever/shaft assembly. Remove adjustment screw from the vacuum control (9S514) and bracket. Remove two bolts retaining ...
...MONITOR SIGNAL CIRCUIT SHORTED TO POWER GROUND. IMRC MONITOR SIGNAL CIRCUIT SHORTED TO SIGNAL GROUND RETURN. IMRC ACTUATOR IS DAMAGED OR THE PCM HAS FAILED. - IMRC - IS INTAKE MANIFOLD RUNNER
Question about 1998 Windstar
control (IMRC) stuck open (bank 1)Description - This DTC is set when the IMRC is commanded closed, but the IMRC monitor indicated open. This DTC replaces P1518 and P1537.Probable causes - IMRC monitor
IMRC control valve, or faulty ECM (engine control module).It is usually the IMRC vacuum solenoid which gets stuck and causes the problem rather than the sensor itself. Hopefully, it stays off for you.
Question about 1998 Windstar
...Control (IMRC) is monitored for failure during continuous or key ON engine OFF self-test. Possible causes - Intake Manifold Runner Control (IMRC) harness is open or shorted - Intake Manifold Runner ...
Question about 1998 Windstar
Control (IMRC) electric actuated system Intake Manifold Swirl Control (IMSC) vacuum actuated system Intake Manifold Tuning Valve (IMTV) These subsystems are used to provide increased intake airflow to
Control (IMRC) monitor signal shorted to power - Faulty Intake Manifold Runner Control (IMRC) actuator - Faulty Intake Manifold Runner Control (IMRC) solenoid - Damage Powertrain Control Module (PCM)
Question about 1998 Windstar
Control (IMRC) Circuit Open (Bank 1) Description: This DTC indicates a failure in the IMRC primary control circuit. This DTC replaces P1520. Possible Causes: IMRC control circuit open Diagnostic Aids:
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions