...works fine. Check the voltage on the 2 wires going to the oven gas valve. If you get 120v when the ignitor is on with no gas coming out, you have a bad gas valve. If you get voltage, but it is not ...
...does not get any gas no blockage from gas control to tube What needs to be replaced? Find the bake ignitor (you may need to remove bottom drawer or oven cavity floor to get to the ignitor). Turn on ...
Question about FEF336BC Electric Kitchen Range
...work Find the bake ignitor (you may need to remove the bottom drawer or oven cavity floor) Turn bake on. If the bake ignitor comes on (starts glowing after a few seconds) - check the amperage on the ...
...work at all, broil works fine Find the bake ignitor (you may need to remove bottom drawer or oven cavity floor to get to the ignitor). Turn on the bake. If the bake ignitor comes on (starts glowing ...
work in broil (hanve not tested cleaning mode). any help would be much appreciated. Find the bake ignitor (you may need to remove bottom drawer or oven cavity floor to get to the ignitor). Turn on the
...the broiler works but i cant use the oven to bake i t says pre heat and does nothing Find the bake ignitor (you may need to remove bottom drawer or oven cavity floor to get to the ignitor). Turn on ...
Question about MGR5755QD CleanDesign Gas Kitchen Range
My Maytag gas range oven is not working. The broiler works okay. Find the bake ignitor (you may need to remove bottom drawer or oven cavity floor to get to the ignitor). Turn on the bake. If the bake ...
...not work, ignitor does not light and replaced with new flat ignitor. broiler flat ignitor works fine, same with range top, all other works. I have power to ignitor. hi, Where can i buy the grate
...work. The ignitor will not glow at all. There is current. Not sure if connectors are oxidized or not. What else could be causing the ignitor not to work? This condition developed suddenly; not over a ...
New ignitors in Viking range oven do not heat up Old Viking VGSC 305 range. Oven ignitors stopped working and I opened it up to find large holes in the burner tubes next to each ignitor. I installed ...
Usually answered in minutes!
924 Questions
608 Questions
343 Questions
293 Questions