Questions & Answers for: Whirlpool where is ignitor

oven will not light/no trbl code/top burners work fine First look to see if the ignitor is coming on. Most common problem is the ignitor is weak or just bad. When the power is applied to the ignitor ...

whirlpool dryer(LGQ9557HQ0), ignitor ignites but flame does not light mounted on top of the gas vavlve is black electrical coils when energized it opens the gas valve,if one of the coils are defective

...heat Need more info. Does it rotate? If it has a viewing door on the front, you may see if the ignitor is glowing. If the ignitor glows, the ignitor (flame) sensor may be bad, and the ignitor ...

...we turned oven on 2 days ago and had no gas to the over. it won't start or bake. Could this be the ignitor? Find the bake ignitor (you may need to remove bottom drawer or oven cavity floor to get to ...

...the pilot light on the dryer? Modern gas dryers do not have a pilot light. They have an electronic ignitor (glow or spark). A glow ignitor turns on several seconds before the gas turns on and should ...

ignitor lights up bright, but no ignition,no flame and I don't hear the gas turn on like I normally do. Top burners work fine. Hello, welcome to fixya ! Based on your description I suspect you have a ...

...running and the timer is set for heat, the control thermostat is energised. It powers up the flame (ignitor) sensor, the ignitor, and the solenoids. The gas does not come out with those solenoids ...

...bottom tray in oven compartment...... usually 2 screws at the rear... Turn it on to bake and see if ignitor glows if not test ignitor for 120v if you have 120v replace the ignitor. If it glows and ...

...it is a whirlpool accubake gas freestanding oven with digital read out. most likely you have a bad ignitor,pull out the racks and remove the floor to the stove,turn on the bake,if the ignitor glows ...

...cold should allow power through it. If it is open internally it will not allow power to get to the ignitor. If you have a meter it should show continuity or 0 on the meter. If you get OL on the