...If there still is no spark you will need to determine if the engine has points or electronic ignition. Most (but not all !) bikes built before 1980 have points ignition. Most bikes built after ...
Question about 2000 VR 2000 Supermoto
...point ignition to electronic ignition? im swapping a points ignition system to electronic ignition on a 1967 mustang.just wanting to do basic setup with magnetic pickupstyle distributor.will i needa ...
...point 4. NO: Change the ignition discharge module and continue with point 4. Final check: Try to start the engine.Did the engine start? YES: The remedial measure taken was correct. NO: The fault is ...
point to have it changed? What remedies I could do or a mechanic could do before it has to be finally changed? Am asking this on the basis of getting stalled anywhere and perhaps could do something to
...point ignition distributor, GM has not used a breaker point ignition for their V-8 engines since 1974, is that an older distributor or something after-market? The ignition points dwell angle for that ...
Question about Profile 30" Self-Cleaning Freestanding Double Oven Gas Range - Stainless-Steel
...ignition. Sometimes the igniter point gets dirty due to food or grease and it will not make a spark check the point. Another issue I've found is that the distance between the point and the burner has ...
Question about Profile 30" Self-Cleaning Freestanding Double Oven Gas Range - Stainless-Steel
...point gap is .012 - .016 inch. Check the ignition timing using the F mark on the flywheel after installing and gapping the new points. Most Honda CB and CL street bikes of similar vintage do need a ...
Question about Profile 30" Self-Cleaning Freestanding Double Oven Gas Range - Stainless-Steel
...like you have concentrated on the HT items. Time to go back and check out the LT circuit from the ignition switch through to the points in the distributor. disconnect the feed going to the coil
Question about Profile 30" Self-Cleaning Freestanding Double Oven Gas Range - Stainless-Steel
...ignition point gap? In older engines with traditional points-condenser-coil ignition systems the dwell if the ignition was set by the gap between the points. The points act like a switch that opens ...
Question about Profile 30" Self-Cleaning Freestanding Double Oven Gas Range - Stainless-Steel
...ignition point . What is the gap on the ignition point . Thanks point gap is .40 to .50 mm ( point 4 to point 5 mm) or .015 to .20" most point distributors are at the .02 " mark but check and adjust ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions