Questions & Answers for: idle 2000 silverado

Silverado 1500, idles up after it warms up My truck starts up with no problems. What i am experiencing is that when it gets warm, usually after about 15 min. it idles up and stays there . If i stop ...

2000 Chevy Silverado Surges between 45 and 55 mph. In other words, I loose hp when the engine idles down at these speeds to about 1200rpm. I have acceleration, but idling at these speed, there is an ...

...2000 silverado 4x4 chev 4.8 has very little power in reverse, TPS was bad and changed, had code cleared and had transmission read and there are no codes at all. Further, truck will idle high and when ...

2000 silverado 4.3 5 speed truck bucks at part throddle while driving.push down on the gas peddle and it gos away let up to just cruse and it surges and bucks again. replaced plugs,wires,cap,rotor.no ...

2000 chevy silverado 5.3 L. When you start it, it will not stay on idles rough than stops. some time after this the electrical fails. no lights etc. a friend suggested checking the module near the air

...idle when starting I have a 2000 Chevy Silverado 2500 with a 6.0L 4x4. Just last week it started up, but wouldn't hold an idle. So I started it and gave it some gas and it would run, but as soon as I ...

2000 Chevy Silverado Step side: the truck seems to be having fuel problems, but they come and go. When it starts messing up the engine won't idle without me giving it constant gas and even then the ...

2000 silverado 4.3 liter, code p1351. idles real rough at 1500 to 1800 rpm and surges while driving. I have replaced the ignition coil the control module plugs wires cap and rotor and egr and ecm and ...

...idle when the engine went erratic to 2000 rpm in park and remained there regardless of any adjustment. When vehicle was put into drive, the rpm dropped to 1000. Put back into park, the rpm went back ...

...idle on my 2000 chevy silverado? after replacing the throttle body sensor, thinking that was the problem the idle on my truck got higher. what should I do to fix this issue? I know this sounds nuts ...