Questions & Answers for: idle drops gear

...idle goes up too 1500 rpm then drops too 1200 rpm and stay but i put it in gear any gear idle goes up at 1500 new maf., tps. sprk.plgs.air+gas filters IAC valve problem. Nissan has a updated harness ...

idle drops down there's your problem. the part number on my 90's was 04288256 but it costs like 236 bucks cause its a vintage part. its so hard to find used parts for these trucks. Good luck hope this

idles @ 2000rpm when 1st gear engaged idle drops idles @ 2000rpm when 1st engaged idle drops to1000rpm.Bike has 94k on the speedo. idle it down carb settings.possibily throttle cabe needs adjusting.

...drops to about 500rpms and lower if idling in drive and dies. sounds like the idle air control vavle. when you put a load on the engine such as putting it in gear or using the ac or turning sharply, ...

...idle drops when i put it in gear almost stalling the engine The idle drops when i put it in gear. Idle is way in park or nuetral. Idle also drops when I turn the ac on.(92 honda accord ex That is ...

revs dont drop im riding a bad boy 1995 im having trouble with the idling when i let go of the throttle it takes 5 or 10 seconds for the revs to go back to to normal idling this makes it difficult to ...

...drops when put in gear idling is fine but when you put it into gear the rpms drop and tries to die. also battery and alt both check fine but if you let the car set over night the battery will be dead ...

...normal idle rpms on an automatic should be around 850rpms as they will drop 250rpms on gear selsction any idle speed around 500 rpms will die when fear is engaged The torque converter could be

...gear the revs drop too low and sometimes the engine stalls This can be either an engine management issue (bad idle air control) or a transmission issue if an automatic trans (torque converter lock up ...

...power the other thing is that when selection a gear the engine rpm is tool low and the alternator stops charging for auto vehicles , the idle rpm should be at 800-900 rpm dropping to 750-800 in ...