Question about 1993 Bronco
93 FORD 302 EFI V-8 USING EXPLODED VIEW DIAG CRACKED METAL TUBE FROM INTAKE MANIFOLD TO UPPER FRONT RIGHT SECTION OF MOTOR (EXTERNAL) Sounds like it is the tube to part of your emissions equipment. It
air gulp pump from pressurizing the crankcase. Mine was shot; had the same symtoms. Also, make sure that the EGR valve is closing at low idle. You don't need an engine light to check the codes. First,
...located in the engine compartment for a 1991 Ford Bronco XLT with a 302 V8? The back up light switch is located on the transmission, left side, it is the trange selector switch as well. Hope this ...
ford bronco 302 idles irratically and stalls when it is put into park. Changed the throttle by-pass valve and it has not improved. Any other ideas? decarbin the trotle body, and i.a.c motor then clear
where is the Idle air control valve located on 90 ford bronco This is the location for a 5.0 ltr full size Bronco.
...well below levels in 2009. What can you guide us to for engine surge? Make sure you have no vacuum leaks and check/replace the Idle Air Control valve, its located on the side of the thottle
...bronco 302 dies riding down the road. wait an hour and starts again and runs, it fluctuates at idle about 4k rpm. changed the fuel filter same results check the fuel PUMP pressure, sounds like its ...
...Air Flow) sensor Bad TPS (Throttle Position Sensor - this controls the idling speed under all conditions. A bad TPS would idle fine under certain conditions ie engine cold, engine warm with AC on etc ...
Question about 1989 Bronco
96 ford bronco 302 v8 stalls out starts right back up & runs fine it is your idle air control vavle
Question about 1990 Bronco
...ford bronco with fuel injected 302 idles and revs fine out of gear but has loss of power and pings when in gear and accelerating... I have a 1990 bronco fuel inject 302 that pings and has a loss of ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions