...car to the clutch pedal) enters the unit. 2nd: If all's well there, you should check for leakage at the slave cylinder, mounted on the side of the trans. This is easily enough identified, as it will ...
...clutch at the g/box SO the master works the slave is the way to identify ? as for diy? yes if you feel confident? after assessing the job why not? be sure to have some fluid?same as brake fluid to ...
...clutch non-return problem. Identify the source of the leak - leaks generally occur at either the master cylinder or the slave cylinder. Replace the leaking unit, re-bleed the system, and your problem ...
...identify problems as they can't see what's happening. As a safety feature it's good to have another person nearby when someone is getting underneath a vehicle. Even my wife has had to do the pedal ...
...identify any clutch fluid (same as brake fluid for the most part) around the area below where the clutch rod comes through the firewall. If you do, that means the clutch master cyliinder is leaking. ...
...clutch slave cylinder, either at the pipe union, the bleed nipple or the cylinder seal. The first two will be obvious to identify on the cylinder itself. The seal leak may well be indicated by drips ...
...adjust or bleed to further identify my problem If the clutch is slipping, you have to replace it. :-( There is nothing to adjust. Make sure you get the whole set, including the pressure
...clutch peddal wont go down. its like it is jammed Try to bleed system from the slave cylinder. If the pedal will go down with bleeder screw open the master and slave cylinders are ok and you have ...
...clutch shooed never push hard i would try looking up in side the inspection plate at the bottom of the transmission covering the fly wheel just top see if you can identify any proublams hope this ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions