Question about A7N8X-E Deluxe NForce 2 Ultra 400 Motherboard (90M7A770GOUAYOZ)
...HDD are in proper configuration. An IDE device have two cofigurations. Master and slave. Any motherboard will have two IDEs. Primary and Secondary. You can connect two drives to one IDE in Master and ...
...IDE hard disk but my system is not detecting two drives at the same time. How can I do it ? You need to set one of the drives to be 'master' and the other to be 'slave'. This is done by positioning ...
Can you tell me if the BIOS will accept the second drive. I would like to install a Seagate Barracuda 7200.10 160Gb ata/ide drive. Sure it will, put the jumper setting on the hdd to cable select mode
Question about HDD 40GB 7200RPM ATA100 2MB (ST340014AP) Hard Drive
...ide drives on the same controller. Question is this: I have two identical seagate 40 gigs attached to the enclosure. The only drive that is detected is the one jumpered as master. It doesn't matter ...
...HDD? If it is used maybe it is bad. Is LBA enabled in the BIOS? Maybe try the secondary IDE BUS. Also try connecting it to the first connector on the IDE BUS rather than at the end.That is all I can ...
...hdd 8 gb i know pathetic but its for young kids to play crappy games. lol. could you tell me how to set this to master. http://www.seagate.com/staticfiles/images/support/en/us/mxo_ata_jumpers_rev.jpg ...
...IDE. plzzzzzzzzzzzzzzzzzzzzzzz help me. At boot up press F2 to enter the BIOS. That is where the change has to be registered for your PC to recognize the new HDD. So when you get the first meny there ...
...hdd, ATA IDE drives connected, make sure that each hdd is jumpered correctly. One set to Master with a slave. The second drive should be jumpered as a slave. If you're running 1 hdd make sure the hdd ...
Question about 80GB 7200 rpm SATA/150 8MB Serial ATA HD REFURBISHED p/n ST380817AS (ST380817ASR) Hard Drive
...IDE hdd it only detects in booting and in bios but after that if i open my computer i cant see my 80gb IDE Hdd and even in device manager my hard disk was not detected?what could be the posilble ...
...HDD "Seagate barracuda 7200.9" ie PATA & SATA intefaces! If it is IDE ie PATA interface, you just set the jumper to Slave. If it is SATA, interface, You cannot "SLAVE" a SATA drive. All SATA ...
Usually answered in minutes!
19,138 Questions
12,216 Questions
7,310 Questions
7,277 Questions
5,472 Questions