Question about MultiPASS C3000 All-In-One InkJet Printer
IDE Controller I/O Port 0x03F6-0x03F6 Primary IDE controller (dual fifo) I/O Port 0x01F0-0x01F7 Intel 82801AA Bus Master IDE Controller I/O Port 0x01F0-0x01F7 Primary IDE controller (dual fifo) IRQ 11
...IDE controller is configured correctly in the BIOS ?Check to make sure that the drive is connected to the correct controller ?Make sure drives are configured correctly for RAID ?Verify Onchip IDE ...
controller if your only going to run IDE's. To set your IDE drive to function as primary master you'll need to have the IDE drive listed in the Boot order sequance. However if you wish to turn off the
IDE controller is ENABLED within BIOS. Set the HDD as Master - see those jumpers next to the power and data connectors. Try with another (IDE) HDD and see if the controller is working. Don't asume the
...IDE cables from my Ultra ATA/ 133 card. Thanks, Professor Yonce.. Whats your suggestion? Sounds like the system is trying to boot from the drives attached to the controller. Go into your setup and ...
...ide 2 or 3 to work with cmos or windows. i've tried disabling the raid controller in cmos , no luck.i'm not familiar with raid so i'm hoping it's something simple i'm not doing.all help appreciated. ...
...screechy noice. go to the HARDWARE part under the SYSTEM options (Control Painel). Under the IDE Controllers part there is PRIMARY IDE and the INTEL one. right click and select UNINSTALL on
Question about (WD3200JS) 320 GB Hard Drive
IDE controller. If the hard drive is connected on the first IDE controller as the second drive then it is jumpered as the SLAVE. If the hard drive is connected to the second IDE controller then it can
...IDE controller. Then install it. OR Buy a SATA hard drive and install it. SATA drives are faster. If you need to get data from your IDE drive to a new SATA drive, try using a IDE slave cable. These ...
...IDE controller end or the hard drive end, so wiggle it in tighter, or unplug and then re-plug it at both ends, and then try to boot. if that does not work, then replace the cable. if a new cable does ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions