replacing clutch in 2002 hyundia accent 2002 hyundia accent are you doing this on the ground or on a lift
...hyundia accent need to know where timing markers are dear friend-on your vehicle cam mark should be at the top,there is a 6mm hole which must line up with a notch on the head.crank must be on TDC and ...
...hyundia accent 1.5 standerd in 1to 3 gear it goes allright i guess but when i go in like 4 to 5 it hesitates like some cilinders arnt going or somthing but its like they all work in the 1 to 3 gears ...
Question about 2001 Accent
...on a Hyundai Accent? where is the windsheild washer motor located on a 2000 Hyundia accent? check under the washer reservoir. Probably accessible by under the front wing skirt. Hope it will help ...
my check engine light is on I have a 2001 Hyundia Accent take the vehicle to auto zone or parts source and they will scan it for free
Hyundia Air conconiditioning proble I just replaced the compressor and compressor switch on my 2001 Hyundai accent and now the air gets cool but not cold? You may not have enough gas into the system. ...
...head cam for a 2001 hyundia accent Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, illustrations,
where is the fuel filter located on a 2001 hyundia accent? On top of the fuel tank beside the fuel pump. Accessible by removing the rear seat and detaching the inspection panel of the fuel pump.
2001 hyundia accent labor time to replace inner tie rod end 2001 accent with 1.6 and ps no more than 1 hr, should really be around 0.7 or 0.8 hrs labor, not including the alingment
Question about 2001 Accent
...hyundia accent will often not start a second time. such as driving to gas station, turn off, get gas, won't restart. your purge control valve is stuck open. replace this valve and you will be as good ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions